econintersect.com
       
  

FREE NEWSLETTER: Econintersect sends a nightly newsletter highlighting news events of the day, and providing a summary of new articles posted on the website. Econintersect will not sell or pass your email address to others per our privacy policy. You can cancel this subscription at any time by selecting the unsubscribing link in the footer of each email.



posted on 02 August 2017

Are You 'Overfat'? Here Are The Best Ways To Tell

from The Conversation

-- this post authored by James Brown, Aston University

About 90% of men and 50% of children in developed countries are "overfat", according to a new study published in Frontiers in Public Health. Most people will be alarmed by these figures ... and the fact that a new term ("overfat") seems to have emerged overnight. What happened to "overweight" and "obese"? Are there different ways of measuring body fat?


Please share this article - Go to very top of page, right hand side, for social media buttons.


Being overweight or obese is normally classified using the body mass index (BMI) system. But BMI is controversial because it doesn't actually take the amount of a person's body fat into account, just their total body weight and their height. This means that short, heavily muscled people can be classified as obese. If body fat is measured instead of body mass, then it is thought that around 70% of people are "overfat", or carrying enough excess body fat that it could impair their health.

Although body fat is essential for normal health, in excess it is a risk factor for a number of diseases, including type 2 diabetes, heart disease and some cancers. This means that measuring body fat is very important because it allows us to predict a person's risk of developing one of these diseases.

It has been shown that BMI fails to identify around half of people with excess body fat, making its use questionable. This means that many normal weight (BMI of 20-24.9) but overfat people may be unaware of the risks that their body fat poses to their health.

When measuring body fat, there are a number of factors that have to be taken into account, and these factors influence which method is used. These include accuracy, invasiveness, cost, availability and ease of use.

The reason BMI is still universally used by healthcare professionals is that it is cheap, non-invasive, and easy to understand and explain. This can also be said, however, of other methods that can better discriminate between body weight and body fat. Other methods also exist that are significantly more accurate at estimating body-fat levels, but these are often impractical or expensive to use.

The relationship between overfat and disease. Maffetone, Rivera-Dominguez and Laursen

The high-tech approach

The best way to accurately assess the amount of body fat a person has is to use imaging technology to scan inside the body. These scans include well-known imaging techniques such as MRI or CT scans, but also lesser known techniques, such as dual-energy X-ray absorptiometry or DEXA scans.

The DEXA scan uses X-rays to give highly accurate measurements of the total weights of fat, lean tissue and bone minerals. This level of information and accuracy makes DEXA stand out among methods of estimating body fat. Importantly, though, there are relatively few DEXA scanners available worldwide and their cost is prohibitive - both to buy and to run.

Other sophisticated technologies exist which are much cheaper and more readily available than imaging, but at a cost to their accuracy. Bioelectrical impedance analysis (BIA) is a non-invasive, low-cost and increasingly common approach for measuring the composition of the body, including body-fat percentage.

This method uses the natural property of electrical resistance that body fat exhibits. Usually, a multi-frequency electrical impulse will be passed through the body between electrodes and an algorithm estimates the level of resistance the percentage of body fat presents. Unfortunately, this method underestimates body fat and is easily biased by eating, drinking or exercise. Although BIA is cheap and available, it is not a gold standard measurement due to its accuracy issues.

... and the low-tech

Beyond high-tech methods, there are simple, non-invasive and cheap ways to estimate body fat that have been shown to be very good at predicting cardiovascular disease risk. These methods are based on measuring the circumference of the waist with a tape measure and comparing it either to the circumference of the hips (waist-to-hip ratio) or height (waist-to-height ratio).

For waist-to-hip ratio, a diagnostic point of 0.9 for males or 0.85 for females for obesity has been suggested by the World Health Organisation. For example, a woman with a 34 inch (86.4cm) waist and 40 inch (101.6 cm) hips has a waist - to-hip ratio of 0.85. Waist-to-hip ratio has been shown to be better than BMI at predicting cardiovascular disease. This method is simple and cheap and, as long as the tape measure is placed at the correct locations, provides good data.

Measuring in the right places is important for an accurate result.

When considering all the factors listed above, possibly the best method for estimating body fat is waist-to-height ratio, the method that was used in the study mentioned earlier that determined that up to 90% of men in the developed world are overfat. The standard way to measure waist-to-height ratio is similar to waist-to-hip, only this time you substitute your height for your hip circumference. A healthy ratio should be 0.5, so your waist circumference should be half your height. For example, a six foot tall man (183cm) with a 36 inch (91.5cm) waist has a waist-to-height ratio of 0.5.

Frontiers in Public Health

Although this method has existed for some time, a newer way of measuring waist-to-height has evolved. This method divides waist size by the square root of height and has been suggested to be the best measure of fat-derived disease risk of all because it gives a reading that works for pretty much everyone, independent of how tall or short they might be.

Waist-to-height ratio has also recently been suggested as being better than BMI at predicting heart disease, while a meta-analysis of studies suggested that waist-to-height ratio is a better screening tool for cardiometabolic disease (diabetes, heart disease and stroke) than waist circumference or BMI.

Getting the message across that BMI isn't the be-all and end-all of metabolic health is important, and for this a clear message is needed. Unless significant steps are made to improve the accuracy of BIA or reduce the cost of DEXA, measurements like waist-to-height ratio are likely to be the best hope of accurately estimating just how overfat we really are in the coming years.

The ConversationThese measurement based tests are incredibly cheap and easy to perform and are backed by a wealth of published data that shows that they outperform BMI. The time for them to be universally adopted by healthcare professionals is long overdue.

James Brown, Lecturer in Biology and Biomedical Science, Aston University

This article was originally published on The Conversation. Read the original article.

>>>>> Scroll down to view and make comments <<<<<<

Click here for Historical News Post Listing










Make a Comment

Econintersect wants your comments, data and opinion on the articles posted. You can also comment using Facebook directly using he comment block below.




Econintersect Contributors








search_box
Print this page or create a PDF file of this page
Print Friendly and PDF


The growing use of ad blocking software is creating a shortfall in covering our fixed expenses. Please consider a donation to Econintersect to allow continuing output of quality and balanced financial and economic news and analysis.







Keep up with economic news using our dynamic economic newspapers with the largest international coverage on the internet
Asia / Pacific
Europe
Middle East / Africa
Americas
USA Government





























 navigate econintersect.com

Blogs

Analysis Blog
News Blog
Investing Blog
Opinion Blog
Precious Metals Blog
Markets Blog
Video of the Day
Weather

Newspapers

Asia / Pacific
Europe
Middle East / Africa
Americas
USA Government
     

RSS Feeds / Social Media

Combined Econintersect Feed
Google+
Facebook
Twitter
Digg

Free Newsletter

Marketplace - Books & More

Economic Forecast

Content Contribution

Contact

About

  Top Economics Site

Investing.com Contributor TalkMarkets Contributor Finance Blogs Free PageRank Checker Active Search Results Google+

This Web Page by Steven Hansen ---- Copyright 2010 - 2017 Econintersect LLC - all rights reserved